The product of lean pipe turnover car will be applied in many fields, whether in factory operation or storage and transportation. Take warehousing and transportation as an example. It will waste a lot of time and manpower if you only rely on manual handling when transporting goods. The use of lean pipe turnover vehicles can greatly improve this situation. Lean pipe turnover vehicles can be used for both turnover and storage of goods, saving time and manpower! In fact, the assembly process of the winding bar turnover car is relatively simple, but there are still some skills to master in the process of assembling the turnover car. Here is a detailed introduction.
1： Before installing the turnover vehicle, you must go through detailed measurement and planning, and remember to communicate with users to try to serve them.
2： One of the holes on the back of the orifice plate is used to connect the orifice plate with the orifice plate. Just use the screws and nuts provided by the exhibition stand, and then connect the two orifice plates from the back to ensure the flatness of the panel and enhance the bearing capacity of the products.
3： The column connector only needs to be inserted into the inner half of the lower column, then tightened with an Allen wrench, and then inserted into the upper column for tightening. The screw position is just opposite to the slot position of the column. What we need to pay attention to is that the screws must be rotated in place, so that when installing the panel, the hook of the panel will not touch these screws, and the panel cannot be inserted into the column slot.
If major enterprises want to better apply the lean pipe turnover vehicle, they can assemble the rod turnover vehicle according to the above correct methods, so as to avoid problems such as the failure of the lean pipe turnover vehicle in the actual application process, and also ensure the working efficiency of the enterprise!
Post time: Dec-21-2022
